A very common hot tub heater assembly for the plastic GS/GL spa packs by Balboa.
Fitted with 24" M7 sensor technology to regulate spa water flow and temperature (Click HERE for Details)
Solvent weld sockets for 2" pipe. Fixed into place with 2 x mounting studs top and bottom.
The heater is the same as 55626, but the heater element is incoloy.
The heater also comes complete with two M7 sensors, pre mounted at each end of the heater tube ready for connection to the control box. These sensors monitor each other using the onboard software to regulate the spas functions of water flow and temperature. This technology allows for a correct operating environment for the heater. The sensors automatically adapt to the flow direction and detect restrictions including dirty filters.
This Balboa heater assembly is quick to install and allows for easy servicing and troubleshooting, due to the split 2" buttress thread unions with O ring. The union is ready to accept glued 2" pipework.
3KW Version
Always match the heater number to ensure the correct specification, the 3kw can be used with GS500, 500Z, 501, 501Z (3.0KW only), 501SZ, 510, 510S, 510Z, 510SZ, 511SZ, 523DZ, GL2000 mach 3, GL2001 mach 3 systems, it is used in spa including Spaform, Hydrospa, Canadian, Aegean, Catalina, Hydropool, , Marquis Spa, , Leisurite, Leisure Bay, Signature Spas, Hot Tubs Direct.
Note:
Always use an appropriate spanner or long nose pliers to hold the terminal base before tightening or loosening the 10mm terminal nuts.
Excellent price and delivery. Only one small criticism the fly leads are a little bit short, but did reach the sockets on the mother board. This was bought to replace a heater by identifying the previous part number and was a direct and straight forward DIY replacement.
Good value you money, extremely efficient from order to delivery. As above sensor leads a little short and only just reached, but heater was easy to fit.
Fast delivery of the product to Denmark. Easy to instal. I saved a lot :-)